3-29
RADIUS Authentication and Accounting
Messages Related to RADIUS Operation
Messages Related to RADIUS Operation
Message Meaning
Can’t reach RADIUS server < x.x.x.x >. A designated RADIUS server is not responding to an
authentication request. Try pinging the server to determine
whether it is accessible to the switch. If the server is
accessible, then verify that the switch is using the correct
encryption key and that the server is correctly configured
to receive an authentication request from the switch.
No server(s)responding. The switch is configured for and attempting RADIUS
authentication, however it is not receiving a response from
a RADIUS server. Ensure that the switch is configured to
access at least one RADIUS server. (Use show radius.) If
you also see the message Can’t reach RADIUS
server < x.x.x.x >, try the suggestions listed for
that message.
Not legal combination of authentication
methods.
Indicates an attempt to configure local
as both the primary
and secondary authentication methods. If local is the
primary method, then none must be the secondary method.
!FishSecurity.book Page 29 Thursday, October 10, 2002 9:19 PM
To Next Page
Loading...
Need help?
General
