5-21
Configuring Port-Based Access Control (802.1x)
Displaying 802.1x Configuration, Statistics, and Counters
Displaying 802.1x Configuration,
Statistics, and Counters
Show Commands for Port-Access Authenticator
802.1x Authentication Commands page 5-10
802.1x Supplicant Commands page 5-17
802.1x-Related Show Commands
show port-access authenticator below
show port-access supplicant page 5-23
RADIUS server configuration pages 5-14
Syntax: show port-access authenticator
Shows whether port-access authenticator is active (Yes
or No) and the status of all ports configured for 802.1x
authentication. The Authenticator Backend State in this
data refers to the switch’s interaction with the authen-
tication server.
[ e ] < port-list >
Same as above, but limits port status to only
thespecified port. The statistics values are blank
if thespecified port is not enabled as an authen-
ticator.
config
Shows whether port-access authenticator is
active and the 802.1x configuration of the speci-
fied port. The configuration settings are blank if
the specified port is not enabled as an authenti-
cator.
!FishSecurity.book Page 21 Thursday, October 10, 2002 9:19 PM
To Next Page
Loading...
