Setting Up Security for a Device
Switch Port Security
14-11
Figure 14-6. Hub Intrusion Log
Switch Port Security
Using Port Security, you can configure each switch port with a unique list of
the MAC addresses of devices that are authorized to access the network
through that port. This enables individual ports to detect, prevent, and log
attempts by unauthorized devices to communicate through the switch.
Basic Operation
The default port security setting for each port is off. That is, any device can
access a port without causing a security reaction. However, on a per-port basis,
you can configure security measures to block unauthorized connections or
“listening”, and to send notice of security violations. Once you have configured
port security, you can then monitor the network for security violations through
one or more of the following:
■ Intrusion flags that are captured by network management tools such as
HP TopTools for Hubs & Switches
■ Alert log entries in the switch's web browser interface
■ Event Log entries in the console interface
■ Intrusion Log entries in either the switch's web browser interface or
console interface
For any port you can configure the following:
■ Authorized Addresses: Specify up to eight devices (MAC addresses) that
are allowed to send inbound traffic through the port. This feature does
the following:
• Closes the port to inbound traffic from any unauthorized devices that
are connected to the port.
To Next Page
Loading...
Need help?
General