4.11.1 DIMM population information
4.11.2 DIMM installation guidelines
4.11.3 Installing a DIMM
4.12 iLO-M.2-serial module option
4.12.1 iLO-M.2-serial module components
4.12.2 Installing the iLO-M.2-serial module
4.13 M.2 SSD options
4.13.1 Installing an M.2 SSD on the system board
4.13.2 Installing the NS204i-p Gen10 Plus Boot Device option
4.13.3 Installing the M.2 SATA SSD enablement option
4.13.4 Installing an M.2 SSD on the iLO-M.2-serial module
4.14 Internal USB device option
4.14.1 Installing an internal USB device
5 Cabling
5.1 Cabling guidelines
5.2 Storage cabling
5.2.1 Drive power cabling
5.2.2 Storage controller cabling
5.2.2.1 4 LFF non-hot-plug drive controller cabling
5.2.2.2 4 LFF / 8 SFF hot-plug drive controller cabling
5.2.3 Energy pack cabling
5.2.4 Storage controller backup power cabling
5.3 Media device cabling
5.3.1 LTO tape drive cabling
5.3.2 RDX backup system cabling
5.3.3 Optical drive cabling
5.4 M.2 SATA SSD add-in card cabling
5.5 Fan cabling
5.5.1 PCI fan cabling
5.5.2 System fan cabling
5.5.3 Heatsink fan cabling
5.6 Serial port cabling
5.7 Front I/O cabling
5.8 Power supply cabling
5.8.1 Non-hot-plug power supply cabling
5.8.2 Flexible Slot power supply cabling
6 Configuration and diagnostic utilities
7 Troubleshooting
7.1 NMI functionality
7.2 Troubleshooting resources
8 System battery replacement
8.1 System battery information
8.2 Removing and replacing the system battery
9 Safety, warranty, and regulatory information
To Next Page
Loading...
Need help?
General
