HP StorageWorks P9000

Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WCheck the Port, GID and
LUN settings of the RCU.
The specified expanded volume in the
RCU is not defined.
87886005
WThe combination of the
specified volumes for LUN
Expansion is not valid.
Verify the parameters and
retry the operation.
Combination of the specified expansion
volumes is not valid.
87896005
WConfirm the status of the
specified expansion volume
and microcode version of
the RCU.
The specified expansion volume
(Port/GID/LUN) of the RCU is not
usable.
87906005
WVary the concerned path
offline from the other host,
then retry the operation.
The specified M-VOL is still online from
another HOST.
87916005
WInstall the Volume Retention
in the MCU and the RCU,
then retry the operation.
The operation failed because the
Volume Retention function was not
installed in the specified RCU.
Install Volume Retention, and retry the
operation.
87926005
WInstall Continuous Access
Synchronous in the MCU
and the RCU, then retry the
operation.
The Continuous Access Synchronous
function is not installed in the specified
controller(s).
87936005
WInstall Continuous Access
Synchronous in the MCU
and the RCU, then retry the
operation.
The Continuous Access Synchronous
function is not installed in the specified
controller(s).
87946005
WCheck the status of the
specified M-VOL from the
host or the SVP.
The operation failed because the
specified M-VOL applied to any of the
following:
• A T-VOL of Business Copy Z which
is not in the Split pair (PSUS) status.
• An S-VOL of Business Copy which
is not in the Split pair (PSUS) status.
• A reserved volume of Business Copy
Z or Business Copy.
• A volume used in Business Copy Z
or Business Copy in Reverse Copy
status.
• A T-VOL of Compatible FlashCopy.
• A FICON(R) Data Migration Source
Volume.
87956005
148 Message (part code group 6nnn)