HP StorageWorks P9000 - Part Code 7105

Table 61 Error codes (part code 7010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EPlease contact HP Technical Support.The P-VOL and the S-VOL belong to
different SLPRs. If you perform this
operation, the storage partition
administrator will become unable to
operate.
Do you want to continue this operation?
590697010
WClick [OK], then continue the operation.Information was updated by other users.
The list will scroll to the top.
661027010
WChange the number of pairs or volumes
displayed in Preview to 16,384 or less.
The maximum number of Pairs or
Volumes that can be displayed in the
Preview List is 16,384. Change the
number of pairs or volumes that is
displayed in the Preview List to 16,384
or less.
665607010
WChange the status of the excluded pair.
Pairsplit operation cannot be executed
from Remote Web Console, if the
specified pair is a Snapshot pair.
Some pairs are excluded from the pairs
to be set, because pairs in invalid status
for Pairsplit operation or Snapshot pair
is included in the specified pairs.
690257010
Part code 7105
Table 62 Error codes (part code 7105)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
50997105
WPlease contact HP Technical Support.An internal logic error occurred.56257105
WRelease the write-protection by Volume
Retention.
The specified volume cannot be used
because it is write-protected by Volume
Retention.
56267105
WWait a while, and retry the operation.Processing in progress. Please wait for
a while, and then retry the operation.
65027105
WWait a while, and retry the operation.The volume status is being changed to
simplex.
65037105
WExecute one of the following:
• Change the attribute of the Security
Group so that the Security Group can
specify T-VOL or reserved volume.
• Remove the volume specified from the
Security Group.
The command has been rejected,
because the specified volume was
registered in the Security Group that
cannot specify T-VOL or reserved volume.
65207105
EIf this problem persists, please contact
HP Technical Support.
This error code is not registered.73107105
WAdd shared memory or confirm whether
the necessary program product key is
installed.
Sufficient amount of shared memory is
not installed or the program product is
not installed.
85007105
WWait a while, and retry the operation.The command has been rejected,
because the command specified last time
is being processed.
85017105
252 Message (part code group 7nnn)