Table 33 Error codes (part code 03022) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting(s).Insufficient free space to create LDEV.10524903022
ECheck the setting(s).Two or more Basic exists together to
External.
10525003022
EPlease operate it again after executing
Shredding.
There is no output file.10525903022
iCheck the setting(s).An LDEV that Snapshot is set has been
selected.
10526303022
iClick [OK] to shred.Volumes that can be shredded in the
selected volumes will be displayed.
10526703022
WSelect the free spaces again from the
Select Free Space window.
The selected status will be canceled
because the number of free spaces that
exist in the selected parity group exceeds
the number that can be set.
10527003022
WSelect the free spaces again from the
Select Free Space window.
The number of free spaces that exist in
the selected parity group exceeds the
number of volumes that can be set.
10527103022
WCheck the setting(s).Data Output cannot be set more than 3.10527203022
iWait for a while, then retry the
operation.
The interruption process cannot be done
because there is an unexecuted specified
task.
10527303022
iThe task status is changed. Close the
window, then check the task status.
The interruption processing was
completed.
10527403022
iCheck the setting(s).The current setting exceeds the maximum
number of quick formatting that can be
executed.
10527503022
WCheck the setting(s).This functionality is not available. Virtual
LVI is required.
10527903022
WCheck the setting(s).This functionality is not available. Open
Volume Management is required.
10528003022
ECheck the setting(s).There is no LDEV that can be formatted.10528103022
WCheck the setting(s).Various system types are mixed in the
selected pools.
10531203022
WWait until the task is complete, and then
retry the operation.
An LDEV cannot be created because the
free space that is available to set has
already been registered in the task.
10531303022
WSelect the emulation type or the free
space again, and then create an LDEV.
In the selected parity group, there is an
area where LDEV cannot be made by
default.
10531403022
Part code 03121
Table 34 Error codes (part code 03121)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WTo continue the processing, click [OK].
Otherwise, click [Cancel].
Are you sure you want to initialize all
the THP pools?
10920503121
Part code 03121 95
To Next Page
Loading...
