HP StorageWorks P9000 - Part Code 6610

Table 55 Error codes (part code 6510) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSpecify different mirror IDs in the mirror
1 and the mirror 2 parameters.
The same mirror ID is specified in the
mirror 1 and the mirror 2 parameters.
657806510
iTo stop the operation, click [OK].
To continue the operation, click [Cancel].
Are you sure you want to cancel the
export?
690166510
WCheck the number of registered journals.No more journals can be registered,
because the number of registered
journals has reached the maximum.
690176510
WCheck the LDKC number for the specified
data volume, and specify only one LDKC
number.
There are two or more LDKC numbers
for the specified data volume. In this
operation, please specify only one LDKC
number.
690186510
WCheck whether the specified volume is
a LUSE volume. Also, check storage
system’s microcode version.
The number of data volumes exceeds the
maximum.
690196510
WCheck the number of registered EXCTG.Journals cannot be added to the
extended consistency group (EXCTG),
because the number of EXCTG exceeds
the maximum.
690216510
WTo continue the operation, click [OK].
Otherwise, click [Cancel].
Do you want to release the remote
command device from the mirror?
690846510
Part code 6610
Table 56 Error codes (part code 6610)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSpecify the data that you want to register
in the SVP, and retry the operation.
The displayed information has not been
changed.
50306610
WCheck the contents, and retry.The Operation value is invalid. Specify
the correct value.
51376610
WCheck the contents, and retry.The value specified for Gathering Interval
is invalid. Specify a valid value within
the range of 1 to 15.
51386610
WSpecify the correct CU number.The specified CU number is incorrect.
Specify the correct CU number.
51406610
WSpecify the correct device number.The specified LDEV number is incorrect.
Specify the correct LDEV number.
51416610
WCheck the values, then specify correct
values.
Some of the entered values are incorrect.
Check the values and then specify
correct values.
51446610
EPlease contact HP Technical Support.An error occurred in client logic.73016610
EPlease contact HP Technical Support.An error occurred in client logic.73026610
EPlease contact HP Technical Support.An error occurred in client logic.73036610
EIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
74406610
222 Message (part code group 6nnn)