HP StorageWorks P9000 - Part Code 9610

Table 85 Error codes (part code 9605) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the logical volume configuration,
then retry the operation.
This logical volume is configured as a
command device.
584389605
WSelect a logical volume whose emulation
type is OPEN-V.
The emulation type of the logical volume
is not OPEN-V.
584429605
WRetry the operation after the logical
volume has recovered from the blocked
status or after the LDEV has been
formatted or shredded.
The specified logical volume is blocked,
or the LDEV is being formatted or
shredded.
584489605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
584509605
WCheck the logical volume configuration,
then retry the operation.
This logical volume cannot be selected
because it is used as a volume for System
Disk.
680029605
WAllocate a resource group of the LDEV.The setting cannot be changed because
there is no access right for a resource
group of the specified LDEV.
750159605
Part code 9610
Table 86 Error codes (part code 9610)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
70609610
WIf this problem persists, please contact
HP Technical Support.
There is an invalid value in the Data
Retention information.
74429610
WMount volumes, then retry the operation.There is no valid volume.81129610
WTo continue processing, click [OK]. To
stop processing, click [Cancel].
The value that is under setup is not
reflected yet. Do you want to continue
the operation?
91079610
iTo change the mode, click [OK].
Otherwise, click [Cancel].
Do you want to change the expiration
lock mode?
93629610
WCorrect the retention term, then retry the
operation.
The specified retention term exceeds the
maximum.
93639610
Part code 9610 305