Table 85 Error codes (part code 9605) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSpecify an open-systems volume.You cannot set a retention term to any
mainframe volumes.
81529605
WCorrect the retention term, then retry the
operation.
The specified retention term exceeds the
maximum.
81539605
WCheck the retention term of the logical
volume, then retry the operation.
The retention term of the logical volume
has been changed by RAID Manager.
81549605
WTo change the access attribute of the
logical volume to Read/Write, please
contact HP Technical Support.
You cannot change the access attribute
because a retention term is set to the
specified logical volume.
81559605
WSet the expiration lock to Disable, then
change the access attribute.
You cannot change the access attribute
because the expiration lock is set to
Enable.
81569605
WRetry the operation after the process is
completed.
The specified operation cannot be
executed because the LDEV shredding
or the LDEV format is being executed.
584049605
WSelect another volume.The attribute of the pool volume cannot
be changed.
584129605
WSelect another volume.The attribute of the virtual volume of the
Snapshot cannot be changed.
584139605
WSelect another volume.The attribute of the P-VOL or the S-VOL
of the Snapshot cannot be changed.
584149605
WRelease or suspend the Continuous
Access Journal volume.
The access attribute cannot be changed,
because the status of the specified
Continuous Access Journal volume is in
"PAIR" or in "COPY."
584189605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
584229605
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
584239605
ERestore the logical volume.The specified logical volume is blocked.584249605
WMake the setting to another logical
volume.
A retention term is set to the specified
logical volume.
584299605
WRetry a little later.This logical volume is busy.584349605
WRetry a little later.This logical volume is busy.584359605
WSee the Data Retention window and
check the following about the logical
volume you have selected:
• The access attribute must be
Read/Write
• The logical volume must be able to
be specified as an S-VOL
• You must be able to set a path to the
logical volume using the RAID
Manager or Remote Web Console
• No mode is set using the RAID
Manager
The access attribute of the logical volume
has already been changed.
584369605
304 Message (part code group 9nnn)
To Next Page
Loading...
