Table 85 Error codes (part code 9605) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
This error code is not registered.73109605
WRetry a little later.An error occurred while connecting to
the subsystem. Please retry a little later.
80019605
WRetry a little later.A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
80029605
ECheck if the DKCMAIN and SVP
microcode versions are mismatched.
This function is not supported.81029605
WSpecify an open-system volume.The specified logical volume does not
exist.
81209605
WRetry a little later.This logical volume is busy.81229605
ECheck if the DKCMAIN and SVP
microcode versions are mismatched.
This function is not supported.81239605
WSpecify an open-system volume.This logical volume is a mainframe
volume.
81249605
WReview LDEV information, then retry.The attribute of the logical volume has
been changed by RAID Manager.
81259605
WCheck the logical volume configuration,
then retry the operation.
This logical volume is configured as a
command device.
81269605
EIf this problem persists, please contact
HP Technical Support.
A parameter error occurred.81289605
EIf this problem persists, please contact
HP Technical Support.
This error code is not registered.81329605
ETo change the attribute, please contact
HP Technical Support.
The attribute of this logical volume
cannot be changed to Read/Write.
81349605
WCheck the logical volume configuration,
then retry the operation.
This logical volume is already used as
an S-VOL for Remote Copy or Business
Copy.
81359605
WThe currently licensed capacity is
insufficient. To increase the licensed
capacity, buy a new license key.
The command was rejected, because the
licensed capacity was exceeded.
81369605
ETo release the Reserved setting, please
contact HP Technical Support.
The Reserved setting of the specified
volume cannot be released.
81389605
WCheck the volume, then retry the
operation.
The specified volume is a P-VOL for
Business Copy.
81399605
WCheck the volume, then retry the
operation.
This logical volume cannot be selected
because it is used as a reserve volume
for Auto LUN.
81419605
WCheck the logical volume, then retry the
operation.
You cannot select this logical volume
because it is used as a Continuous
Access Journal volume.
81429605
WCheck the logical volume, then retry the
operation.
You tried to set a retention term to a
logical volume whose access attribute is
not Read Only or Protect.
81509605
WTo shorten it, please contact HP
Technical Support.
The retention term of the logical volume
cannot be shortened.
81519605
Part code 9605 303
To Next Page
Loading...
