Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the status of the specified
secondary data volume.
The specified secondary data volumes
cannot be paired with another volume,
because the secondary data volume is
used as a journal volume.
582766505
WCheck the data volumes in the specified
secondary journal.
The specified secondary data volume is
not registered in the specified journal.
582776505
WCheck the status of the specified restore
journal.
The specified restore journal is not
registered.
582786505
WCheck the emulation type of the specified
secondary data volume or the restore
journal volume.
The emulation type of the specified
secondary data volume and the restore
journal volume is incorrect due to one of
the following reasons:
• The emulation type is not supported.
• The combination of emulation types
within the journal is incorrect.
• The combination of emulation types
between the journal volumes of the
master and restore journals is
incorrect.
• The emulation types of the primary
and secondary data volumes are not
the same.
582796505
WCheck the status of the specified
secondary data volume.
The specified secondary data group is
already registered.
582806505
WCheck the number of pairs in the
specified restore journal.
No more pairs can be registered in the
specified restore journal.
582816505
WIdentify the journal where the specified
secondary data volume is registered.
The specified secondary data volume is
already registered in another journal.
582826505
WIdentify the journal where the specified
secondary data volume is registered.
The specified secondary data volume
cannot be deleted, because the volume
is already registered in another journal.
582836505
EPlease contact HP Technical Support.An internal error occurred.582846505
WCheck the number of pairs.No more pairs can be registered
because the number of pairs will exceed
the maximum.
582856505
WCheck the command parameters.The command was rejected because the
command was issued to the primary data
volume. The command is supposed to be
issued to the secondary data volume.
582866505
WCheck the command parameters.The command was rejected because the
command was issued to the secondary
data volume. The command is supposed
to be issued to the primary data volume.
582876505
WCheck the status of the specified primary
data volume.
The specified primary data volume is
already paired with another volume.
582886505
WCheck the status of the specified
secondary data volume.
The specified secondary data volume is
already paired with another volume.
582896505
WCheck the status of the specified primary
data volume.
The specified primary data volume is not
paired with any another volume.
582906505
190 Message (part code group 6nnn)
To Next Page
Loading...
