Table 59 Error codes (part code 7005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the target volume number.Boot device and S-VOL do not match in
Paircreate, Pairresync, or Pairsplit-S
instructions.
86547005
WCheck the contents, and retry.An invalid secondary SSID is specified
for the Paircreate or Pairresync
command.
86557005
WCheck the contents, and then retry.The secondary SSID specified for the
pairsplit-S or pairsplit command is
invalid.
86567005
EPlease contact HP Technical Support.The Swap&Freeze option cannot be
specified, because the mode 80 is on.
86577005
WMatch the number of volumes composing
the LUSE volume you intend to specify
as the P-VOL and the number of volumes
composing the LUSE volume you intend
to specify as the S-VOL, then retry the
operation.
The number of volumes composing the
LUSE volume specified as the P-VOL does
not match the number of volumes
composing the LUSE volume specified as
the S-VOL.
86707005
WCorrect the MU number, then retry the
operation.
The specified MU number is not less than
or equal to 2.
86957005
WWait until the L1 pair status becomes
PSUS, and then execute the operation
for the L2 pair.
Because L1 pair is not PSUS, you cannot
execute operations for L2 pair.
89207005
WYou cannot create a pair using these
volumes.
If you want to create a pair by using a
volume without VMA, you must only use
volumes without VMA. If you want to
create a pair by using a volume with
VMA, you must only use volumes with
VMA.
You cannot create a pair with these
volumes.
If you want to create a pair by using a
volume without VMA, you must only use
volumes without VMA. If you want to
create a pair by using a volume with
VMA, you must only use volumes with
VMA.
If you want to create a pair, you must
use the volumes to both of which VMA
is set or not.
The command was rejected because you
tried to create a pair using a volume with
VMA setting by Data Retention and a
volume without VMA setting.
552647005
WIncrease the licensed capacity of Open
System Array Management, then retry
the operation.
You cannot create the pair because the
licensed capacity of Open System Array
Management is insufficient.
553017005
WUse the Reverse Resync option.Quick Restore cannot be executed
because the specified pair is composed
of the external volumes with different
cache mode settings.
556457005
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
563017005
242 Message (part code group 7nnn)
To Next Page
Loading...
