HP StorageWorks P9000 - Page 264

Table 62 Error codes (part code 7105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the requirements for using the
volume with Continuous Access Journal
Z.
The operation failed because the
specified T-VOL was a data volume of
Continuous Access Journal Z.
Check the requirements for using the
volume with Continuous Access Journal
Z.
585367105
EIf this problem persists, please contact
HP Technical Support.
An error occurred on the DKC side. If
this problem persists, please contact HP
Technical Support.
585727105
ECheck if the DKCMAIN and SVP
microcode versions are mismatched.
This function is not supported.585737105
EIf this problem persists, please contact
HP Technical Support.
An error occurred while connecting to
the subsystem. Please wait for a while,
and then retry the operation.
585757105
WVolumes that do not belong to CU group
0 are currently not supported. Specify
another volume.
The operation failed because the CU
group of the specified volume is not
supported.
585857105
WThe command cannot be executed in the
current status of Continuous Access
Journal Z pair.
See the section "Sharing Business Copy
Z volumes" in the HP StorageWorks
P9000 Business Copy for Mainframe
Systems User Guide for the relation
between the state of Continuous Access
Journal Z pair and the Business Copy Z
operations.
The operation failed because the
specified S-VOL was used by Delta
resync of Continuous Access Journal Z.
586307105
WThe P-VOL of Continuous Access Journal
Z pair for Delta resync cannot be
specified as S-VOL. Specify another
volume.
The operation failed because the
specified T-VOL was used by Delta
resync of Continuous Access Journal Z.
586317105
WThe P-VOL of Continuous Access Journal
Z pair for Delta resync cannot be
specified as a reserved volume.
Specify another volume.
The reserve volume setting failed
because the specified volume was used
by Delta resync of Continuous Access
Journal Z.
586327105
WRetry the operation after the Quick
Format has completed.
The command has been rejected,
because Quick Format is performed on
the specified S-VOL.
687437105
WRetry the operation after the Quick
Format has completed.
The command has been rejected,
because Quick Format is performed on
the specified T-VOL.
687447105
WFICON(R) Data Migration source volume
cannot be used as a T-VOL. Use other
volumes.
FICON(R) Data Migration Source Volume
is specified as a T-VOL. FICON(R) Data
Migration Source Volume cannot be used
as a T-VOL.
687457105
WThe specified pair cannot be operated
because the pair uses FICON(R) Data
Migration source volume.
The command has been rejected
because the pair uses FICON(R) Data
Migration Source Volume.
687467105
264 Message (part code group 7nnn)