Table 71 Error codes (part code 8505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EPlease contact HP Technical Support.The same port is already registered in a
different SLPR.
550338505
WInstall the program product.This function is not available.
Open System Array Management is
required to create CLPR.
552288505
iPlease contact the storage administrator.
(To the storage administrator:
Reconfigure the login information. If this
problem persists, please contact HP
Technical Support.)
The login information of the partition
management function has been
initialized due to detection of conflicting
information. Please contact the storage
administrator. (To the storage
administrator: Please reconfigure the
login information.)
565018505
WThe operation to set the maximum
number of connections has been
cancelled because an attempt was made
to specify a value that is less than the
number of users who are currently
connected. Check the maximum
permissible number of connections.
The operation to set the maximum
number of connections has been
cancelled because an attempt has been
made to specify this value to less than
the number of users who are currently
connected. Check the maximum
permissible number of connections.
565028505
EPlease contact HP Technical Support.This function cannot be used by the
storage partition administrator.
565248505
EPlease contact HP Technical Support.While another user is logged into
Remote Web Console, you cannot edit
the information of the SLPR that the user
owns. SLPR No:%s
565278505
WPlease contact HP Technical Support.
Correct the licensed capacity on the
License Key Partition Definition panel.
The licensed capacity was exceeded
because of changing the configuration.
Please correct the licensed capacity on
the License Key Partition Definition panel.
The licensed capacity was exceeded
because the configuration is changed.
565368505
EIf this problem persists, please contact
HP Technical Support.
An unknown error was detected.570028505
WCheck the status of the storage system.
If this problem persists, please contact
HP Technical Support.
Some shared memory of the storage
system may be blocked, or the storage
system is being maintained.
583108505
WCheck the status of the storage system.
If this problem persists, please contact
HP Technical Support.
Some cache memory of the storage
system may be blocked, or the storage
system is being maintained.
583118505
WWait until the write pending rate falls,
then retry the operation.
The configuration cannot be changed
because the write pending rate of the
intended CLPR is too high. Please wait
until the write pending rate falls, and
then retry the operation.
583128505
WCheck the Cache Residency size and the
number of Cache Residency areas.
The configuration cannot be changed
because the available Cache Residency
size or the number of Cache Residency
areas in the intended CLPR is insufficient.
583138505
286 Message (part code group 8nnn)
To Next Page
Loading...
