Table 83 Error codes (part code 9205) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
60239205
EIf this problem persists, please contact
HP Technical Support.
The mistake is found in the set
parameter.
60389205
WWait a few minutes, then retry the
operation.
Processing in progress. Please wait for
a while, and then retry the operation.
65029205
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
65339205
WCheck the error factor in the other
settings.
The setting process has not been
executed because there is no error in this
setting, but an error in the other settings.
65379205
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
70609205
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
71119205
EIf this problem persists, please contact
HP Technical Support.
This error code is not registered.73109205
WRetry a little later.An error occurred while connecting to
the subsystem. Please retry a little later.
80019205
WRetry a little later.A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
80029205
WCheck if the DKCMAIN and SVP
microcode versions are mismatched.
This function is not supported.81029205
WSpecify a mainframe Volume.The specified logical volume does not
exist.
81209205
WSpecify a mainframe Volume.This logical volume is an open volume.81219205
WRetry a little later.This logical volume is busy.81229205
WCheck the logical volume configuration,
then retry the operation.
The logical volume is configured as a
command device.
81269205
WThe currently licensed capacity is
insufficient. To increase the licensed
capacity, buy a new license key.
The command was rejected, because the
licensed capacity was exceeded.
81369205
WConfirm, and operate the volume again.This logical volume cannot be selected
because it is used as a volume for
Compatible FlashCopy.
81409205
WCheck the volume, then retry the
operation.
This logical volume cannot be selected
because it is used as a reserve volume
for Auto LUN.
81419205
WCheck the logical volume, then retry the
operation.
You cannot select this logical volume
because it is used as a Continuous
Access Journal Z volume.
81429205
EIf the problem persists despite retrying,
please contact HP Technical Support.
This function cannot be used by the
storage partition administrator.
565249205
300 Message (part code group 9nnn)
To Next Page
Loading...
