HP StorageWorks P9000

Table 26 Error codes (part code 01022) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WTo change the setting from Target/RCU
Target to Initiator/External, set only 00
to the host group of the target port, set
the host mode to 00 [Standard], and set
all of the host mode options to Disable.
[Enabled] has been set to the Host Mode
Option for the Host Group #00 of the
specified port.
10525301022
WClick [OK], then continue the operation.Some LDEVs or Host Groups that are not
available for LUN path setting are
excluded from the choices.
10527701022
WAllocate the port to any operable
resource group.
The operation cannot be performed
because there is no access right for a
resource group of the specified port.
10529601022
WAllocate the host group to any operable
resource group.
The operation cannot be performed
because there is no access right for a
resource group of the specified host
group.
10529701022
WAllocate the LDEV to any operable
resource group.
The operation cannot be performed
because there is no access right for a
resource group of the specified LDEV.
10529801022
WAllocate the host group to any operable
resource group.
The operation cannot be performed
because there is no access right for a
resource group of the specified host
group.
10530401022
ERefresh the window, then retry the
operation.
If the same problem persists despite
retrying, please contact HP Technical
Support.
The specified port does not exist in the
configuration.
10650101022
ERefresh the window, then retry the
operation.
If the same problem persists despite
retrying, please contact HP Technical
Support.
The specified host group does not exist
in the configuration.
10650201022
ERefresh the window, then retry the
operation.
If the same problem persists despite
retrying, please contact HP Technical
Support.
The process cannot be continued,
because there is no necessary data for
the configuration.
10650301022
WCheck the setting(s).No more host groups cannot be added
to this port, because the number of hosts
that can be set to the target port has
reached the maximum.
10650401022
WCheck the setting(s).No more host groups cannot be set,
because the number of host groups that
can be set to the port has reached the
maximum.
10650501022
ERefresh the window, then retry the
operation.
If the same problem persists despite
retrying, please contact HP Technical
Support.
The specified LU does not exist in the
configuration.
10650601022
Part code 01022 67