HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 195
set config port
Description Sets the port configuration parameters for one or more ports. The changes you make with this
command are not retained when you reset or power-cycle the switch unless you save them using the
config save command.
Authority Admin session and a Config Edit session
Syntax
set config port [port_number]
or
set config ports [port_number]
Operands
port [port_number]
Initiates an edit session in which to change configuration parameters for the port number given
by [port_number]. If you omit [port_number], the system begins with port 0 and proceeds in
order through the last port. For each parameter, enter a new value or press Enter to accept the
current value shown in brackets. Enter q to end the configuration for one port, or qq to end the
configuration for all ports. Table 33 describes the port configuration parameters.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all ports based on
the configuration for the port given by [port_number]. If you omit [port_number], port 0 is used.
For each parameter, enter a new value or press Enter to accept the current value shown in
brackets. Enter q to end the configuration. Table 33 describes the port configuration parameters.
Table 33 Port configuration parameters
Parameter Description
AdminState Port administrative state:
• Online—Activates and prepares the port to send data. This is the
default.
• Offline—Prevents the port from receiving signal and accepting a
device login.
• Diagnostics—Prepares the port for testing and prevents the port from
accepting a device login.
• Down—Disables the port by removing power from the port lasers.
LinkSpeed Transmission speed:
• SFP ports: 2 Gb/s, 4 Gb/s, 8 Gb/s, or Auto. The default is Auto. 8
Gb/s SFPs do not support the 1 Gb/s setting. Settting a port to 1
Gb/s that has an 8 Gb/s SFP downs the port.
• XPAK ports: 10 Gb/s, 20 Gb/s, Auto
PortType Port types:
• SFP ports: GL, G, F, FL, Donor. The default is GL.
• XPAK ports: G, F. The default is G.
SymbolicPortName Descriptive name for the port. The name can be up to 32 characters
excluding #, semicolon (;), and comma (,). The default is Port n, where
n is the port number.
ALFairness Arbitration loop fairness. Enables (True) or disables (False) the
switch’s priority to arbitrate on the loop. The default is False.
DeviceScanEnabled Enables (True) or disables (False) the scanning of the connected
device for FC-4 descriptor information during login. The default is True.

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English