72 Zoning Configuration
Merged zone set information
A merged zone set is a zone set that is received from another switch as a result of a change to the active
zone set. You can display the merged zone set on your switch if the MergeAutoSave parameter is set to
False. For more information about the MergeAutoSave parameter, see ”Configuring the zoning
database” (page 75). To display merged zone set information, enter the zoning merged command, as
shown in the following example:
SN6000 FC Switch #> zoning merged
*********************************************************************
To permanently save the merged database locally, execute the
'zoning merged capture' command. To edit the merged database
use the ’zoning edit merged’ command. To remove the merged database
use the ’zoning restore’ command.
**********************************************************************
Merged (unsaved) Zoning Information
ZoneSet Zone ZoneMember
------- ---- ----------
ZS1
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa
Z2
10:00:00:c0:dd:00:b9:fb
10:00:00:c0:dd:00:b9:fc
Edited zone set information
The edited zone set is a zone set that you were modifying when a change occurred to the active zone set
or a fabric merge occurred. To display the unsaved edited zone set information, enter the
zoning edited command in an Admin session and a Zoning Edit session, as shown in the following
example:
SN6000 FC Switch (admin-zoning) #> zoning edited
Edited (unsaved) Zoning Information
ZoneSet Zone ZoneMember
------- ---- ----------
ZS1
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa
Zone set membership information
The zoneset zones, zone list, and zone zonesets commands display zone set membership
information.
To display the member zones for a specified zone set, enter the zoneset zones command, as shown in
the following example:
SN6000 FC Switch #> zoneset zones ssss
Current List of Zones for ZoneSet: ssss
----------------------------------
zone1
zone2
zone3
To Next Page
Loading...
Need help?
General