42 Switch Configuration
Managing switch services
You can configure your switch to suit the demands of your environment by enabling or disabling a variety
of switch services using the set setup services commands. To display the status of the switch
services, use the show setup services command. See Table 49 for descriptions of the switch services
settings.
IMPORTANT: Simple SAN Connection Manager version 1.0 does not support the SSL service. If SSL is
enabled, you will be unable to manage the switch using this version of Simple SAN Connection Manager.
To display the current switch services settings, enter the show setup services command, as shown in
the following example:
SN6000 FC Switch #> show setup services
System Services
-----------------------------
Telnet Enabled True
SSHEnabled False
GUIMgmtEnabled True
SSLEnabled False
EmbeddedGUIEnabled True
SNMPEnabled True
NTPEnabled True
CIMEnabled True
FTPEnabled True
MgmtServerEnabled True
CallHomeEnabled True
To Next Page
Loading...
Need help?
General