HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 223
ipv4
Prompts you in a line-by-line fashion to change the switch IPv4 Ethernet configuration parameters
described in Table 53. To configure all system parameters, omit the operand. For each
parameter, enter a new value or press Enter to accept the current value.
NOTE: Changing the IP address will terminate all Ethernet management sessions.
Table 53 IPv4 Ethernet configuration parameters
Parameter Description
EthIPv4NetworkEnable Enables (True) or disables (False) the IPv4 interface. The default
is True.
EthIPv4NetworkDiscovery Ethernet boot method:
• 1—Static
• 2—Bootp (Bootstrap Protocol)
• 3—DHCP (Dynamic Host Configuration Protocol)
• 4—RARP (Reverse Address Resolution Protocol)
The default is 1-Static.
EthIPv4NetworkAddress Ethernet IP address. The default is 10.0.0.1.
EthIPv4NetworkMask Ethernet subnet mask address. The default is 255.0.0.0.
EthIPv4GatewayAddress Ethernet IP address gateway. The default is 10.0.0.254
Operands
ipv6
Prompts you in a line-by-line fashion to change the switch IPv6 Ethernet configuration parameters
described in Table 54. To configure all system parameters, omit the operand. For each
parameter, enter a new value or press Enter to accept the current value.
NOTE: Changing the IP address will terminate all Ethernet management sessions.
Table 54 IPv6 Ethernet configuration parameters
Parameter Description
EthIPv6NetworkEnable Enables (True) or disables (False) the IPv6 interface. The
default is True.
EthIPv6NetworkDiscovery Ethernet boot method:
• 1—Static
• 2—DHCPv6 (Dynamic Host Configuration Protocol)
• 3—NDP (Neighbor Discovery Protocol)
The default is Static.
EthIPv6NetworkAddress Ethernet IP address
EthIPv6GatewayAddress Ethernet IP address gateway.

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English