HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 201
e
set config switch
Description Sets the switch configuration parameters. The changes you make with this command are not retained
when you reset or power-cycle the switch unless you save them using the config save command.
Authority Admin session and a Config Edit session
Syntax
set config switch
This command initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value. For each parameter,
enter a new value or press Enter to accept the current value shown in brackets. Table 36 describes
the switch configuration parameters.
Table 36 Switch configuration parameters
Parameter Description
AdminState Switch administrative state.
• Online—Activates and prepares the ports to send data. This is
the default.
• Offline—Prevents the ports from receiving signal and accepting
a device login.
• Diagnostics—Prepares the ports for testing and prevents the
ports from accepting a device login.
• Down—Disables the ports by removing power from the port lasers.
BroadcastEnabled Broadcast. Enables (True) or disables (False) forwarding of
broadcast frames. The default is True.
InbandEnabled Inband management. Enables (True) or disables (False) the ability
to manage the switch over an ISL. The default is True.
FDMIEnabled Fabric Device Monitoring Interface (FDMI). Enables (True) or disables
(False) the monitoring of target and initiator device information. The
default is True.
FDMIEntries The number of device entries to maintain in the FDMI database. Enter
a number from 0–1,000. The default is 1000.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic reassignment of the
domain ID. The default is False.
SymbolicName Descriptive name for the switch. The name can be up to 32 characters
excluding #, semicolon (;), and comma (,). The default is SN6000 FC
Switch.
R_A_TOV Resource Allocation Timeout Value. The number of milliseconds the
switch waits to allow two ports to allocate enough resources to
establish a link. The default is 10000.
E_D_TOV Error Detect Timeout Value. The number of milliseconds a port is to
wait for errors to clear. The default is 2000.
PrincipalPriority The priority used in the FC-SW-2 principal switch selection algorithm. 1
is high, 255 is low. The default is 254.
ConfigDescription Switch configuration description. The configuration description can be
up to 32 characters excluding #, semicolon (;), and comma (,). The
default is Config Default.

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English