HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 61
Modifying port operating characteristics
You can make permanent or temporary changes to port operating characteristics. The
set config port command makes permanent port configuration changes. These changes are saved in
the active configuration and are preserved across switch or port resets. The set port command makes
temporary changes that apply until the next port or switch reset, or until you activate a configuration.
IMPORTANT: 8 Gb/s SFPs do not support the 1 Gb/s setting. Setting a Fibre Channel port that has an
8-Gb/s SFP transceiver to 1-Gb/s will down the port.
The following example permanently changes port administrative state of port 1:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> config edit
SN6000 FC Switch (admin-config) #> set config port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number: 1
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online] offline
LinkSpeed (1=1Gb/s, 2=2Gb/s, 4=4Gb/s, 8=8Gb/s, A=Auto) [Auto ]
PortType (GL, G, F, FL, TR) [GL ]
SymPortName (string, max=32 chars) [Port1 ]
ALFairness (True / False) [False ]
DeviceScanEnable (True / False) [True ]
ForceOfflineRSCN (True / False) [False ]
ARB_FF (True / False) [False ]
InteropCredit (decimal value, 0-255) [0 ]
FANEnable (True / False) [True ]
AutoPerfTuning (True / False) [True ]
MSEnable (True / False) [True ]
NoClose (True / False) [False ]
IOStreamGuard (Enable / Disable / Auto) [Auto ]
PDISCPingEnable (True / False) [True ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
SN6000 FC Switch (admin-config) #> config save
SN6000 FC Switch (admin-config) #> config activate
You can configure all ports based on a specified source port using the set config ports command.
The set config ports command prompts you to configure the parameters of the source port, and then
applies those values to all of the ports. The following example configures all ports based on port 3:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) config edit
SN6000 FC Switch (admin) #> set config ports 3
.
.
.
SN6000 FC Switch (admin-config)#> config save
SN6000 FC Switch (admin)#> config activate
SN6000 FC Switch (admin)#> admin end

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English