HP StorageWorks SN6000

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 57
5 Port Configuration
This section contains port configuration information.
Displaying port information
You can display the following port information:
• Port configuration parameters, page 57
• Port operational information, page 58
• Port threshold alarm configuration parameters, page 59
• Port performance, page 60
• Transceiver information, page 60
Port configuration parameters
To display the port configuration parameters, enter the show config port command. These
parameters determine the operational characteristics of the port. See Table 33 for descriptions of these
parameters.
SN6000 FC Switch #> show config port 3
Configuration Name: default
-----------------------------
Port Number: 3
------------
AdminState Online
LinkSpeed Auto
PortType GL
SymbolicName Port3
ALFairness False
DeviceScanEnabled True
ForceOfflineRSCN False
ARB_FF False
InteropCredit 0
ExtCredit 0
FANEnabled True
AutoPerfTuning True
MSEnabled True
NoClose False
IOStreamGuard Auto
PDISCPingEnabled True