HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 315
zoning merged
Description Displays the contents of the merged zone set, or saves the merged zone set to the non-volatile zoning
database.
Authority Admin session for the capture operand.
Syntax
zoning merged
capture
Operands
capture
Saves the merged zone set to the non-volatile zoning database. You must enter the
zoning save command to save your changes. If you omit this operand, this command displays
the contents of the merged zone set.
Examples The following is an example of the zoning merged command:
SN6000 FC Switch #> zoning merged
*********************************************************************
To permanently save the merged database locally, execute the
'zoning merged capture' command. To edit the merged database
use the ’zoning edit merged’ command. To remove the merged database
use the ’zoning restore’ command.
**********************************************************************
Merged (unsaved) Zoning Information
ZoneSet Zone ZoneMember
------- ---- ----------
ZS1
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa
Z2
10:00:00:c0:dd:00:b9:fb
10:00:00:c0:dd:00:b9:fc
The following is an example of the zoning merged capture command:
SN6000 FC Switch (admin) #> zoning merged capture
This command will overwrite the configured zoning database in NVRAM.
Please confirm (y/n): [n] y
The merged zoning database has been saved.
See also zoning configured, page 308
zoning edited, page 311
zoning list, page 314
To Next Page
Loading...
Need help?
General