HP StorageWorks SN6000 Command Line Interface Guide

270 Command Reference
show setup snmp
Description Displays the current SNMP settings.
Authority None
Syntax
show setup snmp
common
trap [trap_number]
Operands
common
Displays SNMP configuration parameters that are common to all traps. To display common and
trap-specific parameters, omit the operand. See Table 50 for descriptions of the common
configuration parameters.
trap [trap_number]
Displays SNMP configuration parameters for the trap given by [trap_number]. To display
common and trap-specific parameters, omit the operand. See Table 51 for descriptions of the
trap-specific configuration parameters.
Examples The following is an example of the show setup snmp common command:
SN6000 FC Switch #> show setup snmp common
SNMP Information
----------------
SNMPEnabled True
Contact <sysContact undefined>
Location <sysLocation undefined>
Description HP StorageWorks SN6000 Stackable Dual Power Supply
Fibre Channel Switch
ObjectID 1.3.6.1.4.1.3873.1.25
AuthFailureTrap True
ProxyEnabled True
SNMPv3Enabled False
The following is an example of the show setup snmp trap command:
SN6000 FC Switch #> show setup snmp trap 1
SNMP Information
----------------
Trap1Enabled False
Trap1Address 10.0.0.254
Trap1Port 162
Trap1Severity warning
Trap1Version 2
See also set setup snmp, page 219

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English