To Next Page

To Previous Page

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 209

set pagebreak

Description Specifies how much information is displayed on the screen at a time. This command is useful for

disabling pagebreaks to allow command scripts to run without interruption.

Authority None

Syntax

pagebreak [state]

Operands

[state]

Table 43 describes the pagebreak state parameters.

Table 43 Pagebreak state parameters

Parameter Description

on Limits the display of information to 20 lines at a time. The page break function

affects the following commands:

• alias (list, members)

• show (alarm, log)

• zone (list, members)

• zoneset (list, zones)

• zoning (active, list)

off Allows continuous display of information without a break. This is the default.

Examples The following is an example of the set pagebreak command:

SN6000 FC Switch #> set pagebreak on

SN6000 FC Switch #> zone list

Zone ZoneSet

---- -------

Zone1

alpha

beta

Zone2

delta

echo

Zone3

sierra

tango

Zone4

gamma

delta

Press any key to continue, 'q' to quit ...

HP StorageWorks SN6000 Command Line Interface Guide

Other manuals for HP StorageWorks SN6000