208 Command Reference
restore
Restores and saves the port, component, and level settings to the default values.
save
Saves the log settings for the component, severity level, port, and display level. These settings
remain in effect after a switch reset. The log settings can be viewed using the
show log settings command. To export log entries to a file, use the set log archive
command.
start
Starts the logging of events based on the port, component, and level operands assigned to
the current configuration. The logging continues until you enter the set log stop command.
stop
Stops logging of events.
Notes In addition to critical, warn, and informative severity levels, the highest event severity level is alarm.
The alarm level describes events that are disruptive to the administration or operation of a fabric and
require administrator intervention. Alarms are always logged and always displayed on the screen.
See also show log, page 249
To Next Page
Loading...
Need help?
General