HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 75
Zoning database limits
To display a summary of the objects in the zoning database and their maximum limits, enter the
zoning limits command, as shown in the following example:
SN6000 FC Switch #> zoning limits
Configured (saved in NVRAM) Zoning Information
Zoning Attribute Maximum Current [Zoning Name]
---------------- ------- ------- -------------
MaxZoneSets 256 6
MaxZones 2000 17
MaxAliases 2500 1
MaxTotalMembers 10000 166
MaxZonesInZoneSets 2000 19
MaxMembersPerZone 2000
10 D_1_JBOD_1
23 D_1_Photons
9 D_2_JBOD1
16 D_2_NewJBOD_2
5 E1JBOD1
5 E2JBOD2
3 LinkResetZone
3 LinkResetZone2
8 NewJBOD1
8 NewJBOD2
24 Q_1Photon1
8 Q_1_NewJBOD1
13 Q_1_Photon_1
21 Q_2_NewJBOD2
3 ZoneAlias
3 ZoneDomainPort
4 ZoneFCAddr
MaxMembersPerAlias 2000
2 AliasInAZone
ActiveZones 19
ActiveZoneMembers 160
To display abbreviated limits information, enter the zoning limits brief command.
Configuring the zoning database
You can configure how the zoning database is applied to the switch and exchanged with the fabric by
using the zoning configuration parameters. The following zoning configuration parameters are available
through the set config zoning command. For more information about the zoning configuration
parameters, see Table 38.
• MergeAutoSave—Enables or disables the automatic saving of a new active zone set to the switch
non-volatile zoning database.
• DefaultZone—Allows or denies communication among ports/devices that are not defined in the
active zone set.
• DiscardInactive—Enables or disables the discarding of all zone sets except the active zone set.

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English