HP StorageWorks SN6000

248 Command Reference
show interface
Description Displays the status of the active network interfaces.
Authority None
Syntax
show interface
Examples The following is an example of the show interface command:
SN6000 FC Switch #> show interface
eth0 Link encap:Ethernet HWaddr 00:C0:DD:00:00:27
inet addr:10.20.116.131 Bcast:10.20.116.255 Mask:255.255.255.0
inet6 addr: fd70:c154:c2df:116:2c0:ddff:fe00:27/64 Scope:Global
inet6 addr: fe80::2c0:ddff:fe00:27/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:137168 errors:0 dropped:0 overruns:0 frame:0
TX packets:2194 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:47764214 (45.5 Mb) TX bytes:328639 (320.9 Kb)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.255.255.255
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:3887 errors:0 dropped:0 overruns:0 frame:0
TX packets:3887 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:272461 (266.0 Kb) TX bytes:272461 (266.0 Kb)