To Next Page

To Previous Page

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 215

The following is an example of the set setup radius server command:

SN6000 FC Switch (admin) #> set setup radius server 1

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the attributes

for the server being processed, press 'q' or 'Q' and the ENTER key to do so.

If you wish to terminate the configuration process completely, press 'qq' or

'QQ' and the ENTER key to so do.

PLEASE NOTE:

-----------

* SSL must be enabled in order to configure RADIUS User Authentication

SSL can be enabled using the 'set setup services' command.

Server 1 Current Values:

ServerIPAddress 10.20.11.8

ServerUDPPort 1812

DeviceAuthServer True

UserAuthServer True

AccountingServer False

Timeout 10

Retries 0

SignPackets False

Secret **********

New Server 1 Value (press ENTER to accept current value, 'q' to skip):

ServerIPAddress (hostname, IPv4, or IPv6 address) :

ServerUDPPort (decimal value) :

DeviceAuthServer (True / False) :

UserAuthServer (True / False) :

AccountingServer (True / False) :

Timeout (decimal value, 1-30 secs) :

Retries (decimal value, 1-3, 0=None) :

SignPackets (True / False) :

Secret (1-63 characters, recommend 22+) :

Do you want to save and activate this radius setup? (y/n): [n]

HP StorageWorks SN6000 Command Line Interface Guide

Other manuals for HP StorageWorks SN6000