HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 221
The following is an example of the set setup snmp trap command:
SN6000 FC Switch (admin) #> set setup snmp trap 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
Trap1Enabled True
Trap1Address 10.20.33.181
Trap1Port 5001
Trap1Severity info
Trap1Version 2
Trap1Community northdakota
New Value (press ENTER to not specify value, 'q' to quit):
Trap1Enabled (True / False) :
Trap1Address (hostname, IPv4, or IPv6 Address) :
Trap1Port (decimal value, 1-65535) :
Trap1Severity (select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark :
Trap1Version (1 / 2) :
Trap1Community (string, max=32 chars) :
Do you want to save and activate this snmp setup? (y/n): [n]
See also show setup snmp, page 270
To Next Page
Loading...
Need help?
General