HP StorageWorks SN6000 - Page 237

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 237
The following is an example of the show config port command for an XPAK port:
SN6000 FC Switch #> show config port 20
Configuration Name: default
-----------------------------
Port Number: 20
------------
AdminState Offline
LinkSpeed 10Gb/s
PortType G
SymbolicName 10G-20
DeviceScanEnabled True
ForceOfflineRSCN False
AutoPerfTuning False
LCFEnabled False
MFSEnabled True
VIEnabled False
MSEnabled True
IOStreamGuard Disabled
PDISCPingEnable True
See also set config port, page 195