HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 291
Examples The following example performs an online test on port 1:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> test port 1 online
A list of attributes with formatting and current values will follow. Enter a
new value or simply press the ENTER key to accept the default value. If you
wish to terminate this process before reaching the end of the list press 'q'
or 'Q' and the ENTER key to do so.
LoopCount (decimal value, 1-4294967295) [429496729]
FrameSize (decimal value, 40-2148) [256 ]
DataPattern (32-bit hex value or 'Default') [Default ]
StopOnError (True / False) [True ]
LoopForever (True / False) [False ]
Do you want to start the test? (y/n) [n] y
The test has been started.
A notification with the test result(s) will appear
on the screen when the test has completed.
SN6000 FC Switch (admin) #>
Test for port 1 Passed.
See also test cancel, page 289
test status, page 292
test switch, page 294
To Next Page
Loading...
Need help?
General