Recommended action
When creating a Business Copy pair, you cannot create the S-VOL when the pair status is not
PSUS. Make the pair status PSUS using Storage Management Software.
E2002045
Message
Preparation of S-Vol LUs failed.
Explanation
Could not create S-VOL.
Recommended action
An error occurred when an operation command was given to the disk array system. See “About
errors attributable to disk array systems” (page 133).
E2002046
Message
The LU is not found.
Explanation
While waiting for format completion, S-VOL is not found.
Recommended action
During S-VOL creation, operation might have been interrupted by Storage Management Software,
and the P-VOL or S-VOL may have been deleted or the pair status might have been changed.
Confirm the existence of P-VOL and S-VOL and check the pair status using Storage Management
Software.
E2002048
Message
Creating S-Vol... failed. The specified LU is in regressed status.
Explanation
Creation of S-VOL failed.
Recommended action
A failure occurred in the specified RAID /Parity group or THP (Smart) pool. Re-execute after
resolving the failure.
E2002049
Message
Initialization of S-Vol LU failed. Initialization of S-VOL failed.
116 Troubleshooting
To Next Page
Loading...
Need help?
General
