HP XP - E10000 Cb

Recommended action
Interrupt action was performed by using Storage Management Software while backing up or
creating an S-VOL using the GUI Tool. P-VOL or S-VOL might have been deleted or the pair
status might have been changed. Confirm the existence of P-VOL and S-VOL and pair status
using Storage Management Software
E10000CB
Message
Remove LU mapping failed - P-Vol: [LU number of P-VOL] S-Vol: [LU# of Secondary VOL].
Explanation
Cannot remove LU# mapping of secondary VOL (V-VOL/S-VOL).
Recommended action
An error occurred when an operation command was given to the disk array system.
See “About errors attributable to disk array systems” (page 133).
E10000CD
Message
Failed to delete S-Vol: [LU number of S-VOL].
Explanation
Cannot delete S-VOL.
Recommended action
An error occurred when an operation command was given to the disk array system.
See “About errors attributable to disk array systems” (page 133).
E10000D0
Message
Failed to delete Snapshot pair - P-Vol: [LU number of P-VOL] V-Vol: [LU number of V-VOL].
Explanation
Cannot delete Snapshot pair.
Recommended action
An error occurred when an operation command was given to the disk array system.
See “About errors attributable to disk array systems” (page 133).
E10000D1
Message
Delete V-Vol failed for V-Vol: [LU number of V-VOL].
Explanation
Cannot delete V-VOL.
Recommended action
An error occurred when an operation command was given to the disk array system.
Error messages 89