HP XP - Placement Location of Command Device Which Is Connected to Host; Support Scope of HA Configuration; Adapter Function

Table 3 Support scope of RSG assignment of each resource (continued)
SupportPrivilege for RSGRSG AssignmentResource
Non-SupportedWith privilegeDifferent RSG from
P-VOL
Non-SupportedWithout privilege
SupportedWith privilegeSame RSG as P-VOLHost group ID
Non-SupportedWithout privilege
Non-SupportedWith privilegeDifferent RSG from
P-VOL
Non-SupportedWithout privilege
SupportedWith privilegeSame RSG as P-VOLPool (THP/Smart/FS)
1
Non-SupportedWithout privilege
SupportedWith privilegeDifferent RSG from
P-VOL
Non-SupportedWithout privilege
1
Pool is not managed by RSG. However, a pool created only by LDEV which belongs to specific RSG can only be used
by a user who has RSG privileges.
NOTE: Even if P-VOL to be operated is assigned in meta_resource, it can be used if a user
has appropriate privileges.
Placement location of command device which is connected to host
Place a command device in each physical DKC when a command device is used in multiple
virtual DKCs.
Table 4 Support scope of placement location of command device which is connected to
host
RemarksSupportPlacement location
SupportedOnly command device in physical
DKC
Connecting only command device in
physical DKC to host is required.
Non-SupportedOnly command device in virtual DKC
Same as above.Non-SupportedCommand device in physical DKC
and virtual DKC
Support scope of HA configuration
This subsection indicates the support scope of HA configuration.
Adapter function
Table 5 Support scope of adapter function
RemarksSupportFunctionTarget
SupportedCreation of secondary VOLPrimary site only
SupportedRemoval of secondary VOL
SupportedSecondary VOL pair
operations
SupportedSecondary VOL mapping
24 Environmental Prerequisites