Figure 11 Setting Example of RAID Manager Instance No
The following is an example of the startup procedure for RAID Manager (HORCM).
Setup
• The file name of the HORCM_CONF configuration file: [horcm700.conf] (The number part [700]
of the file name is the instance number.)
• Instance number: [700]
• Installation folder of RAID Manager (HORCM): [C: \HORCM]
Start up procedure
1. Copy the HORCM_CONF configuration file (horcm700.conf) to the C: \HORCM\etc folder.
2. Open the command prompt and enter the following commands:
a. > CD C: \HORCM\etc
b. C: \HORCM\etc> SET HORCM_CONF=C: \HORCM\etc\horcm700.conf
c. C: \HORCM\etc> SET HORCMINST=700
d. C: \HORCM\etc> horcmstart.exe
NOTE: If the startup fails in step d, confirm that the instance number, the installation folder,
and the command device settings are specified correctly. For the details, see the RAID Manager
User’s Guide.
Preparing a disk array system
Shown below are the procedures for preparing a disk array system.
Preparing a disk array system 45
To Next Page
Loading...
