[RestoreMode=NORMAL]
• Snapshot resync mode — Specify an operation mode in the backup processing that uses
the Snapshot function.
◦ When Snapshot resync mode is enabled, perform a backup operation using V-VOLs in
PAIR status and resynchronize the pair after completing the backup. If no V-VOLs in
PAIR status exist, create new V-VOLs and a Snapshot pair, perform a backup operation,
and resynchronize the pair after completing the backup.
◦ When Snapshot resync mode is disabled, create new V-VOLs and a Snapshot pair,
perform a backup operation, and delete the created V-VOLs after completing the backup.
◦ If the value is omitted or an invalid value is used, Snapshot resync mode uses the default
value (OFF).
Formatting:
[SnapshotResyncMode=ON]
[SnapshotResyncMode=OFF]
Log output level and log type:
• MINIMAL:
INFO◦
◦ ENTER/EXIT
◦ Default (STAT, WARN, ERROR, PARAM
• NORMAL (Recommended level):
INFO◦
◦ ENTER/EXIT
◦ DBG1
◦ Default (STAT, WARN, ERROR, PARAM
• VERBOSE
◦ All
• Not specified (blank):
◦ Default (STAT, WARN, ERROR, PARAM)
Log division and log type:
• Default log outputs:
STAT — The processing status (success or failure of processing) is output.◦
◦ WARN — The processing of VSS Provider continues, but important warnings are output.
User edit files 41
To Next Page
Loading...
Need help?
General
