HPE FlexFabric 5950 Series User Manual

78
57B
Configuring DS-TE
DS-TE is configurable on any node that an MPLS TE tunnel traverses.
To configure DS-TE:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter MPLS TE view.
mpls te
N/A
3. (Optional.) Configure the DS-TE
mode as IETF.
ds-te mode ietf
By default, the DS-TE mode is
prestandard
.
4. (Optional.) Configure the BC
model of IETF DS-TE as MAM.
ds-te bc-model mam
By default, the BC model of IETF
DS-TE is RDM.
5. Configure a TE class.
ds-te te-class
te-class-index
class-type
class-type-number
priority
priority
The default TE classes for IETF
mode are shown in
730H
Table 1.
In prestandard mode, you cannot
configure TE classes.
Table 1 Default TE classes in IETF mode
TE Class CT Priority
0 0 7
1 1 7
2 2 7
3 3 7
4 0 0
5 1 0
6 2 0
7 3 0
58B
Configuring an MPLS TE tunnel to use a static
CRLSP
To configure an MPLS TE tunnel to use a static CRLSP, perform the following tasks:
• Establish the static CRLSP.
• Specify the MPLS TE tunnel establishment mode as static.
• Configure the MPLS TE tunnel to use the static CRLSP.
Other configurations, such as tunnel constraints and IGP extension, are not needed.
To configure an MPLS TE tunnel to use a static CRLSP:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a static CRLSP.
See "
731H
Configuring a static CRLSP." N/A

HPE FlexFabric 5950 Series Specifications

General

Brand	HPE
Model	FlexFabric 5950 Series
Category	Switch
Language	English