HPE FlexFabric 5950 Series

148
Auto Bandwidth : Disabled Auto Bandwidth Freq : -
Min Bandwidth : - Max Bandwidth : -
Collected Bandwidth : -
# Display bandwidth information on interface VLAN-interface 1 on Switch A.
[SwitchA] display mpls te link-management bandwidth-allocation interface vlan-interface
1
Interface: Vlan-interface1
Max Link Bandwidth : 10000 kbps
Max Reservable Bandwidth of Prestandard RDM : 0 kbps
Max Reservable Bandwidth of IETF RDM : 10000 kbps
Max Reservable Bandwidth of IETF MAM : 0 kbps
Allocated Bandwidth-Item Count : 1
Allocated Bandwidth : 0 kbps
Physical Link Status : Up
BC Prestandard RDM(kbps) IETF RDM(kbps) IETF MAM(kbps)
0 0 10000 0
1 0 8000 0
2 - 5000 0
3 - 2000 0
TE Class Class Type Priority BW Reserved(kbps) BW Available(kbps)
0 0 0 0 0
1 0 1 0 0
2 0 2 0 0
3 0 3 0 0
4 0 4 0 0
5 0 5 0 0
6 0 6 0 0
7 0 7 0 0
# Execute the display ip routing-table command on Switch A. The output shows a static route entry
with interface Tunnel 1 as the output interface. (Details not shown.)
68B
Troubleshooting MPLS TE
205BNo TE LSA generated
427BSymptom
OSPF TE is configured but no TE LSAs can be generated to describe MPLS TE attributes.
428BAnalysis
For TE LSAs to be generated, a minimum of one OSPF neighbor must reach FULL state.
429BSolution
1. To resolve the problem:
a. Use the display current-configuration command to verify that MPLS TE is configured on
involved interfaces.
b. Use the debugging ospf mpls-te command to verify that OSPF can receive the TE LINK
establishment message.