392
Step Command Remarks
interface after configuring this
command.
307BConfiguring route related attributes for a VPN instance
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter VPN instance view or
IPv6 VPN view.
• Enter VPN instance view:
ip vpn-instance
vpn-instance-name
• Enter IPv6 VPN view:
a. ip vpn-instance
vpn-instance-name
b. address-family ipv6
Configurations made in VPN
instance view apply to both IPv4
VPN and IPv6 VPN.
IPv6 VPN prefers the
configurations in IPv6 VPN view
over the configurations in VPN
instance view.
3. Configure route targets.
vpn-target
vpn-target&<1-8>
[
both
|
export-extcommunity
|
import-extcommunity
]
By default, no route targets are
configured.
4. Set the maximum number of
active routes.
routing-table
limit
number
{ warn-threshold |
simply-alert
}
By default, the number of active
routes in a VPN instance is not
limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from storing
too many routes.
5. Apply an import routing
policy.
import route-policy
route-policy
By default, all routes matching the
import target attribute are
accepted.
Make sure the routing policy
already exists. Otherwise, the
device does not filter received
routes.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
6. Apply an export routing
policy.
export route-policy
route-policy
By default, routes to be advertised
are not filtered.
Make sure the routing policy
already exists. Otherwise, the
device does not filter routes to be
advertised.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
7. Apply a tunnel policy to the
VPN instance.
tnl-policy
tunnel-policy-name
By default, only one tunnel is
selected (no load balancing). The
LSP tunnel takes precedence
over the CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "
880H
Configuring tunnel
policies."
To Next Page
Loading...
Need help?
General