HPE FlexFabric 5950 Series

160
214BProtocols and standards
• RFC 2205, Resource ReSerVation Protocol
• RFC 3209, RSVP-TE: Extensions to RSVP for LSP Tunnels
• RFC 2961, RSVP Refresh Overhead Reduction Extensions
74B
RSVP configuration task list
Tasks at a glance
(Required.)
747H
Enabling RSVP
(Optional.) Perform the following tasks on each node of an MPLS TE tunnel according to your network
requirements:
•
748HConfiguring RSVP refresh
• 749HConfiguring RSVP Srefresh and reliable RSVP message delivery
• 750HConfiguring RSVP hello extension
• 751HConfiguring RSVP authentication
• 752HSetting a DSCP value for outgoing RSVP packets
• 753HConfiguring RSVP GR
• 754HEnabling BFD for RSVP
75B
Enabling RSVP
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable global RSVP and enter
RSVP view.
rsvp
By default, global RSVP is
disabled.
3. Return to system view.
quit
N/A
4. Enter interface view.
interface
interface-type
interface-number
N/A
5. Enable RSVP on the interface.
rsvp enable
By default, RSVP is disabled
on the interface.
76B
Configuring RSVP refresh
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter RSVP view.
rsvp
N/A
3. Set the refresh interval for
Path and Resv messages.
refresh interval
interval
By default, the refresh interval is
30 seconds for both path and
Resv messages.
4. Set the PSB and RSB
timeout multiplier.
keep-multiplier
number
By default, the PSB and RSB
timeout multiplier is 3.