NOTE
The default outbound interface cannot be a broadcast interface, such as an Ethernet interface.
Step 6 Run:
apply ip-address next-hop ip-address1 [ ip-address2 ]
The next hop of the packet is specified.
NOTE
The next hop cannot be a local IP address.
Step 7 Run:
apply output-interface interface-type interface-number
The outbound interface of the packet is specified.
NOTE
The outbound interface cannot be a broadcast interface, such as an Ethernet interface.
Step 8 Run:
apply access-vpn vpn-instance vpn-instance-name &<1-6>
The VPN instance allowed to be accessed is specified.
The apply ip-precedence command is used to set the precedence of the packet. The value of
precedence ranges from 0 to 7. In addition, some key words can be used as the value of
precedence. Table 8-1 shows the relationship between key words and precedence.
Table 8-1 Relationship between keywords and precedence
Precedence
Key Word
0 Routine
1 Priority
2 Immediate
3 Flash
4 Flash-override
5 Critical
6 Internet
7 Network
----End
Follow-up Procedure
Note the following when defining actions in PBR:
l A policy can include multiple apply clauses, which can be used in combination.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 8 IP Unicast PBR Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
196
To Next Page
Loading...
