Huawei ATN 950B - PGND Cables

Cable Item Description
Technical
specifications of the
W1 wire
Wire, 600 V, 14AWG, Black, UL1015
Fireproof class CM
Output power cable
connecting to the
PIU
Cable type (H4(5.08))-(2 x 18UL1015 Blue + 2 x
18UL1015 Black)-(2 x Cord End 2.0^2
Yellow (2 x 1.0))
Technical
specifications of the
X1 connector
Ordinary plug, 4PIN, single row /5.08 mm
(0.20 in.)
Technical
specifications of the
W1/W2 wire
Wire, 600 V, 18AWG, Blue, UL1015
Technical
specifications of the
W3/W4 wire
Wire, 600 V, 18AWG, Black, UL1015
Technical
specifications of the
X2/X3 terminal
Naked Crimping Terminal, Twin Cord End
Terminal, 2 mm
2
(0.003 in.
2
), Insertion Depth
8 mm(0.31 in.), 23 A,Tin Plating, Yellow, 2
x 1.0 mm
2
Fireproof class CM
Note 1: A power cable is named in the format of "Connector 1 Type-Cable Material Type-
Connector 2 Type".
Note 2: The specifications of power cables for inputting the mains vary in different countries
or regions. In this document, the AC power cables complying with international standards are
considered as examples.
9.1.3 PGND Cables
PGND cables are used to ground the ATN 950B.
PGND cables are made of wires and OT terminals. Figure 9-6 shows the appearance of a PGND
cable. The technical specifications of the PGND cable are listed in Table 9-2.
ATN 950B Multi-service Access Equipment
Hardware Description 9 Cables
Issue 03 (2012-07-23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
93