Huawei ATN 950B - 75-Ohm 16 X E1 Cables

9.4.2 75-Ohm 16 x E1 Cables
On the ATN 950B, Anea96 connectors are used to input and output 75-ohm E1 signals.
At one end of the 75-ohm 16 x E1 cable, the Anea96 connector is used to connect the 75-ohm
E1 electrical interface on the board; the other end is connected to the digital distribution frame
(DDF). Make the connector as required on site.
Structure
Figure 9-14 shows the appearance of the 75-ohm 16 x E1 cable and Figure 9-15 shows the
structure of the cable.
Figure 9-14 Appearance of the 75-ohm 16 x E1 cable
Figure 9-15 Structure of the 75-ohm 16 x E1 cable
Main label
1
W
X1
A
View A
Pos .1
Pos.96
Cable Connector, Anea, 96PIN,
Female Connector
Pin Assignment
Table 9-15 lists the pin assignment of the 75-ohm 16 x E1 cable connector.
ATN 950B Multi-service Access Equipment
Hardware Description 9 Cables
Issue 03 (2012-07-23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
103