Huawei ATN 950B - 120-Ohm 16 X E1 Cables

Connecto
r Pin
Cable Remarks Connecto
r Pin
Cable Remarks
Core Serial No. Core Serial No.
53 Tip 29 R14 77 Tip 30 T14
54 Ring 78 Ring
55 Tip 31 R15 79 Tip 32 T15
56 Ring 80 Ring
Shell External braid shield layer
Technical Specifications
Table 9-16 Technical specifications of the 75-ohm 16 x E1 cable
Item Specification
Cable Trunk Cable, 75ohm, 16E1, 1.6mm,Anea 96F-
I,SYFVZP75-1.1/0.26*32(S), +45deg
Connector Cable Connector, Anea, 96PIN, Suite Of Female Connector And
Shielding Case, IDC Type, For 28-30 AWG Solid Wire, 1 A
Cable type Coaxial Cable, SYFVZP-MC 75-1-1*32, 75 ohm, 12.40 mm(0.49
in.), 1.1 mm(0.04 in.), 0.26 mm(0.01 in.), Pantone Warm Gray 1U,
Only for OEM
Diameter of the shield
layer - diameter of the
internal insulation
layer - diameter of the
internal conductor
12.4 mm(0.49 in.) - 1.6 mm(0.06 in.) - 0.26 mm(0.01 in.)
Number of cores 32
Available length 5 m, 10 m, 15 m, 20 m, 25 m, 30 m, 35 m, 40 m, 45 m, 50 m
16.40 ft.,32.80 ft.,49.21 ft.,65.62 ft.,82.02 ft.,98.42 ft.,114.83 ft.,
131.23 ft.147.64 ft.,164.04 ft.
9.4.3 120-Ohm 16 x E1 Cables
On the ATN 950B, Anea96 connectors are used to input and output 120-ohm E1 signals.
At one end of the a 120-ohm 16 x E1 cable, the Anea96 connector is used to connect the 120-
ohm E1 electrical interface on the board; the other end is connected to the DDF. Make the
connector as required on site.
ATN 950B Multi-service Access Equipment
Hardware Description 9 Cables
Issue 03 (2012-07-23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
105