Huawei E9000 - Using the MM910 Webui to Collect Information in Batches (for Versions Earlier than U54 2.20); Using the MM910 Webui to Collect Information in Batches (for U54 2.20 or Later)

8.4 Using the MM910 WebUI to Collect Information in
Batches (for Versions Earlier Than U54 2.20)
Operation Scenario
For versions earlier than (U54) 2.20, use the MM910 WebUI to collect logs in
batches.
Procedure
Step 1 Log in to the MM910 WebUI. For details, see 8.11 Logging In to the MM910
WebUI.
Step 2 Choose System Management on the menu bar, choose SEL Information in the
navigation tree, and click the SMM tab and then the One touch collect tab.
The log collection page is displayed.
Step 3 On the log collection page, choose Collect All > Start.
Log collection takes about 20 minutes. When log collection is complete, a log
le
named one_touch_info_all.tar.gz is displayed in the File Name area.
Step 4 Click the log
le name and download it to the local PC as prompted.
NO TE
For MM910 earlier than (U54) 2.20, you need to collect logs of both the active and standby
HMMs.
----End
8.5 Using the MM910 WebUI to Collect Information in
Batches (for U54 2.20 or Later)
Operation Scenario
For (U54) 2.20 or later, use the MM910 WebUI to collect logs in batches.
Procedure
Step 1 Log in to the MM910 WebUI. For details, see 8.11 Logging In to the MM910
WebUI.
Step 2 Choose System Management > Information Collection, and set log collection
parameters.
● Select MM for Collected from.
● Select One-click full collection for Collected content.
Step 3 Click Collect.
Huawei Servers
Troubleshooting 8 Common Operations
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 138