Huawei E9000 - Using the Web Tools Page of a Switch Module to Collect FC Switching Plane Information (MX510)

switch modules are not stacked, log in to each switch module and repeat the
preceding log collection procedure.)
[ftp]mkdir swi2
[ftp]cd swi2
[ftp]mput 2#ash:/logle/*
[ftp]cd ..
[ftp]quit
221 Windows FTP Server (WFTPD, by Texas Imperial Software) says goodbye
<HUAWEI>
NO TE
– When you use the mput command in the FTP CLI, 2#ash:/ indicates the ash
root directory of the switch module with the stack ID 2. You can obtain the stack
ID and role information by using the display stack command.
– The ash root directory of the master switch module in a stack is ash:/.
– If multiple switch modules are displayed after running the display stack
command, obtain the log le of each switch module in the logle directory.
4. View the log le in the FTP directory on the PC.
----End
4.4.2.5 Using the Web Tools Page of a Switch Module to Collect FC
Switching Plane Information (MX510)
Operation Scenario
Use Web Tools page of a switch module (MX510) to collect information about the
FC switching plane.
This section applies to the CX311, CX911, and CX915.
Prerequisites
Conditions
● The connection between the management IP address of the FC switch module
and the server IP address is normal.
● You have logged in to the Ethernet switching plane Web Tools page. For
details, see 8.10 Logging In to the Web Tools of the MX510.
Data
Table 4-7 Data list
Parameter
Example Value
IP address 192.168.1.100
Subnet mask 255.255.255.0
Default gateway 0.0.0.0
Huawei Servers
Troubleshooting 4 Collecting Information
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 28