Huawei E9000 - Page 36

Enter password:
230 Logged in successfully
[ftp]binary
200 Type is Image (Binary)
# On the FTP server, create a log receiving directory for the master switch
module in the stack. In this example, the number 3 in swi3 indicates the stack
ID (same as the slot number) of the master switch module. (If the switch
modules are not stacked, create a log receiving directory for the current
switch module. The number 3 in swi3 indicates the slot number of the current
switch module.)
[ftp]mkdir swi3
[ftp]cd swi3
[ftp]put
ash:/diag-info.txt
200 Port command successful.
150 Opening data connection for diag-info.txt.
/ 100% [***********]
226 File received ok
FTP: 1756870 byte(s) send in 0.308 second(s) 5570.431Kbyte(s)/sec.
[ftp]mput
ash:/logle/*
200 Port command successful.
150 Opening data connection for diag.log.
/ 100% [***********]
226 File received ok
FTP: 7971326 byte(s) send in 0.798 second(s) 9755.010Kbyte(s)/sec.
200 Port command successful.
150 Opening data connection for diaglog_3_20140221182310.log.zip.
/ 100% [***********]
226 File received ok
FTP: 444920 byte(s) send in 0.113 second(s) 3845.061Kbyte(s)/sec.
200 Port command successful.
150 Opening data connection for diagnostic_information.zip.
/ 100% [***********]
226 File received ok
FTP: 1756870 byte(s) send in 0.308 second(s) 5570.431Kbyte(s)/sec.
200 Port command successful.
150 Opening data connection for log.log.
/ 100% [***********]
226 File received ok
FTP: 4272491 byte(s) send in 3.492 second(s) 1194.832Kbyte(s)/sec.
200 Port command successful.
150 Opening data connection for log_3_20131222113233.log.zip.
/ 100% [***********]
226 File received ok
FTP: 354428 byte(s) send in 0.238 second(s) 1454.289Kbyte(s)/sec.
200 Port command successful.
150 Opening data connection for log_3_20140116085018.log.zip.
/ 100% [***********]
226 File received ok
FTP: 353715 byte(s) send in 0.265 second(s) 1303.486Kbyte(s)/sec.
[ftp]cd ..
# On the FTP server, create a log receiving directory for the standby or slave
switch module in the stack. In this example, the number 2 in swi2 indicates
the stack ID (same as the slot number) of the master switch module. (If the
Huawei Servers
Troubleshooting 4 Collecting Information
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 27